04-03-2008 12:06 AM - edited 03-15-2019 09:49 AM
Hi experts,
We just upgraded the firmware of our 7941s. All are good except one. It doesn't upgrade at all. I factory reset it by holding #, 123456789*0#.
After this, it's still not fixed. Then I directly connected it to a laptop as TFTP server with SEPxxxxxx.cnf, term41.defaults.loads, etc. with it.
However the phone is not responding at all. Then I factory reset it again the 2nd time. Now the speaker button & line button blink once, then it's dead. no power.
I also tried connecting a power supply but the same happens. the speaker button & line button blink once, then it's dead.
Can anyone help me how to troubleshoot it? Or the only thing I should do is forward it to TAC?
tnx
04-03-2008 10:35 AM
Try the alternate reset sequence:
3491672580*#
After that, wait, it can take 10 minutes without display activity to revive the phone.
Hope this helps, please rate post if it does!
04-03-2008 11:34 AM
Hi,
Is it the same sequence (factory reset)for 7912? I have few phones that dont reboot after upgrading firmware to 8.04.
Thanks
04-03-2008 06:25 PM
thanks p.bevilacqua
Tried it but no success!
any more idea?
tnx
04-04-2008 04:33 AM
Do packet capture and you will see that either the phone is not give a valid dhcp reply with option 150, or it reuest some file that the tftp server doesn't give.
04-20-2008 10:40 PM
Hi Can anyone give me what should be on the SEP
thanks
04-21-2008 03:24 AM
What do you have, CM or CME ? check that the ephone is configured correctly in there.
04-21-2008 02:42 PM
CM with 7941G sccp phone.
firmware:SCCP41.8-3-4SR1S
tnx
04-21-2008 06:46 PM
Finally I was able to fixed it.
tnx
06-02-2008 08:15 AM
How about description of how the problem was solved, then at least these postings are usefull.
06-19-2009 06:49 AM
Hello, I'm facing the same problem. Could you please share with me what was done to fix the issue? Thank you.
06-22-2009 12:01 AM
The only thing that I've done is set a specific pc as a TFTP server, then I copied all the phone's files from my CM for that particular model. Then when all was set, i reset it as advised then it works!
hth
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: