Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

IP Phone Number Display

Hi All,

I have a requirement on Cisco Call Manager something like below scenarion.I am running CCM version 7.1.5

1. I am calling from my IP Phone to my Mobile.

2. When i call from IP Phone to my mobile i get display in my mobile as the number of IP Phone ( Incoming Number).

3. Is there any way where i can restrict the number of my ip phone to display on my mobile ?

Thanks & Regds,

Lalit

5 REPLIES
Hall of Fame Super Gold

Re: IP Phone Number Display

Do you use ISDN PRI? Or analog lines ?

New Member

Re: IP Phone Number Display

Hi ,

I use PRI Lines on my Gateway. I just want to know whether this can be achieved through route pattern or the service parameter options.

Thanks & Regds,

Lalit

Hall of Fame Super Gold

Re: IP Phone Number Display

Yes, add a route pattern with a prefix of your choice like *67#, configure so the prefix is discarded but calling party presentation restricted.

That will set a certain bit in ISDN Q931 so that calling number is restricted.

New Member

Re: IP Phone Number Display

Hi ,

We have put a route pattern with " Calling Line ID Presentation " Value as " Restricted " even then we are seeing complete directory number of source ip phone being displayed on the mobile phone.

Thanks & Regds,

Lalit

Hall of Fame Super Gold

Re: IP Phone Number Display

On the gateway, take "debug isdn q931" with "term mon".

224
Views
0
Helpful
5
Replies