I have about 100 Cisco 7911 deloyed in a hospital and every week I have problems with them, because patients change the RJ45 from the switch port to the PC port and the phone stops working (bored people is very dangeorus if they have a phone with a lot of buttons).
I have changed the softkey template to only allow "New call", but the problem with the wire change is still giving me problems.
Is there any way to "replicate" the switch port to the PC port, so it doesn't mind in what connector is pluged the RJ45 wire?
I have seen that systems before, but I can't change the installation (it has been installed 4 moths ago, if I say now that they have to reinstall all the connectors, they will kill me XD ), so I need to protect it by software.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...