Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

IP Phone power problem

I have a 3750 POE. When i connect 7911 to it via patch panel it gets power, when i connect 7940 / 7960 with it through patch panel it doesnt get power while the same phones get power if i directly plug the phone into 3750. On console i am also gettinf following messages

ILPOWER-5-IEEE_DISCONNECT

Everthing was working fine before this

Any clue ?

ILPOWER-5-IEEE_DISCONNECT

3 REPLIES
Hall of Fame Super Gold

Re: IP Phone power problem

See below for meaning of message. I suggest thay you check with a cable tester that all wires in your cabling systems are correctly paired.

Error Message ILPOWER-5-IEEE_DISCONNECT: Interface [chars]: AC disconnect

Explanation This message means that the powered device is no longer connected to the switch or that the connected powered device is being powered by an external AC power source. No power is on the switch PoE port. [chars] is the interface.

Recommended Action No action is required.

New Member

Re: IP Phone power problem

The wires are ok. Moreover everthing was working fine on these wires earlier.But they are still ok.

Hall of Fame Super Gold

Re: IP Phone power problem

Can you try rebooting the switch then ?

307
Views
0
Helpful
3
Replies