we have a cisco ip phone solution (CCM version 4.1) in our company, the problem is when we connect laptop to the data network specially to the internet via the IPphone the connection is very slow comparing with connect the laptop directly to the switch.
This is usually a problem of duplex mismatch between IP Phone and Laptop/pc.
To resolve this, Go to settings>>>>3(Netwk Config)>>>>>>39 (switch Port Config)...check the setting on it.
If this is setup for Auto/whatever it is then you should have your pc have same setting....
To see your pc setting..
Go to the LAN connection, click on properties, the network card you are using shows, click on configure whicc is a tab beside the card....when the new tab opens, click on advanced...you will see the settings for the pc under speed and duplex..
chnage the value to match the setting on the ip phone and you should be good.
Please rate all useful posts
"The essence of christianity is not the enthronement but the obliteration of self --William Barclay"
thanks for your replay, i do what you recommend me to do, but the problem still existing, so is there special configuration or special action to avoid the problem , because it is relly make the internet so slow and there is a big difference between connect internet directly from connect it via ip phone
it hav't happens with all places in my network, some places (i mean interfaces) work normal ,at first i though it is because the phone , but when i replace the phone that work normal with that has problem, i have got the same result
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.