IP Phones 7906 & 7911 not supported by CCM 4.1(3) ?
I'm using a CCM 4.1(3) and i cannot register IP Phones 7906 & 7911. These are not available in 'Phone type drop-down list'. Is this CCM 4.1(3) can be upgrade to support these phones ? which patch ? how ?
This Cisco Unified IP Phone 7906G and 7911G firmware release is supported with the following Cisco Unified CallManager versions. If you are running Cisco Unified CallManager release 3.0, 3.1, or 3.2, you must upgrade to Cisco Unified CallManager release 3.3(5) or later before you install this firmware release.
â¢Cisco Unified CallManager version 3.3(5) SR1 or later
â¢Cisco Unified CallManager version 4.0(2a) SR2b or later
â¢Cisco Unified CallManager version 4.1(3) SR1 or later
and also you need ciscocm.4-1-DevPack-25.3.exe, or later
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...