IP Phones w/AnyConnect on ASA. Can't call other remote phones
I also posted this in the VPN forum:
I have a CUCM BE environment with a number of remote users with 8961 phones connecting to an ASA 5501 via AnyConnect. The phones register fine and can make inbound/outbound calls as well as four digit dialing to other users at the corporate site.
The problem is when a remote user tries to four digit dial another remote phone. The called phone will ring but there is dead air once answered and then the line goes dead.
This sounds like a routing issue to me. Can anyone point me in the right direction to get AnyConnect clients to be able to reach each other?
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...