I faced the high CPU on IPCC and found error SS1002. According to the Cisco document, this error will occur when you install the second NIC and incorrect about the order of NIC. if i have two NICs on CRS, but the second NIC was disabled (for long time before this issue). Beside this error SS1002, i also found the two error codes that was SS3101 and SS1004. Anyone can give solutions to fix it?
Personally, if the NIC is disabled - I don't see where NIC bindings can cause an error BUT in an unrelated case, I had a similar situation and it was suggested to me by TAC that I should change the NIC binding order so that NIC1 was in priority order and the disabled NIC2 was secondary.
You may have misunderstood my post - my comment was an opinion that it's hard for me to see how NIC bindings
affect the server if one NIC is DISABLED but I'm not disputing that it can't, doesn't, or won't. If you've seen that those errors correlate to the NIC bindings then I would change them to the correct order and reboot the server...then monitor to see if you have any repeat issues.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...