Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Silver

IPMA and Translation Patterns

We are considering using IPMA, however the single route point is an issue. We could have Manager's DNs (which can't change) which could be anywhere in the XXXX range, but we already have a route pattern for XXXX which routes non-IP destinations towards the legacy PBX. A RP of XXXX would intercept these calls.

One option is to identify a smaller number of DNs for IPMA use, e.g. 110X and then use translation patterns to map manager's DNs onto these DNs. Would this work, or does the Manager's DN need to be presented to IPMA without translation?

1 REPLY
Bronze

Re: IPMA and Translation Patterns

Hi,

You can assign multi DNs to a single cti rp, up to about 10,000 of them. Use multi specific numbers and you should be fine.

HTH, Avner.

94
Views
0
Helpful
1
Replies