Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

is it possible to change the sip port in a cue?

hi, i had to change the sip port that the cme uses to establish sip connections, the new port is 5061, so i want to know if in the cue, could i change that port?

1 ACCEPTED SOLUTION

Accepted Solutions
VIP Purple

Re: is it possible to change the sip port in a cue?

Yes, you can. Try the following commands. Keep in mind the port for your CUE module could be different.

router#service-module service-engine 0/0 session

cue#conf t

cue(config)#ccn subsystem sip

cue(config-sip)#gateway port 5061

Hope this helps.

Brandon

1 REPLY
VIP Purple

Re: is it possible to change the sip port in a cue?

Yes, you can. Try the following commands. Keep in mind the port for your CUE module could be different.

router#service-module service-engine 0/0 session

cue#conf t

cue(config)#ccn subsystem sip

cue(config-sip)#gateway port 5061

Hope this helps.

Brandon

124
Views
0
Helpful
1
Replies
CreatePlease to create content