Is it possible to use WS-SVC-CMM-24FXS to connect to a asterisk pbx and not use UCS at all?
I am needing just a few analog lines made available to the asterisk pbx that I am using for the majority of my calls. I just got a catalyst 6509 and noticed that it had the fxs module available. The price of the used fxs is no worse than any pci/e phone card I could get for the vm running asterisk and would keep me from having to assign hardware to a guest. I do not want to have to run the cisco call manager on another vm to connect the 2 pieces. Is there any possible solutions to getting the fxs card to talk to asterisk?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...