Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Is my hardware settings ok (MGCP, ipsec and Q.SIG Gw)? (easy for most of U ^^)

Hello there,

Following my precedent request, I need advises about the better router I can choose for this architecture:

CUCM ----- [GW] ----- MGW Alcatel ----- OXE

The control proto are these:

CUCM --|MGCP|--- [GW] --|QSIG|--- MGW Alcatel ----- OXE

And security features like this:

CUCM --|MGCP over IPSEC, SRTP|--- [GW] --|QSIG|--- MGW Alcatel ----- OXE

So, i was about advises for this GW hardware settings:

  • Cisco 2821
  • NM-HDV2-2T1/E1
  • Latest IOS version Advanced Enterprise Services

Do you think it's enough?

Cheers,

1 REPLY
Cisco Employee

Re: Is my hardware settings ok (MGCP, ipsec and Q.SIG Gw)? (easy

Gregory,

That should work fine. Below is some additional documentation on the supported models and devices.

http://www.cisco.com/en/US/prod/collateral/routers/ps259/product_data_sheet0900aecd8016c784_ps5855_Products_Data_Sheet.html

Biggest thing you have to consider is sizing. Will the 2821 have enough capacity to support the number of concurrent calls in this deployment?

-Felipe

143
Views
0
Helpful
1
Replies
CreatePlease to create content