11-05-2007 04:44 AM - edited 03-15-2019 07:03 AM
Hi,
Is it possible to configure a NM-4B-S/T for voice support?
I explain:
I want to use a NM-4B-S/T to connect to the PSTN on a c2811. But when I configure the dial-peer pots, there is no voice port.
Is it possible?
Thanks
11-05-2007 05:32 AM
Hi Solo,
Sorry, this card is a NM - Network Module and will not support Voice :( There are some VIC - Voice interface choices that will work listed in this doc;
http://www.cisco.com/en/US/products/hw/modules/ps5365/products_data_sheet09186a0080191d41.html
Hope this helps!
Rob
11-05-2007 06:26 AM
If I want to use 4 BRI for Voice, what is your suggestion?
Thanks
11-05-2007 06:28 AM
Either 2 x VIC2-2BRI-NT/TE, or an addon module for EVM, (that is useable only on 2821 and bigger router).
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: