Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Is possible to configure NM-4B-S/T BRI for voice?

Hi,

Is it possible to configure a NM-4B-S/T for voice support?

I explain:

I want to use a NM-4B-S/T to connect to the PSTN on a c2811. But when I configure the dial-peer pots, there is no voice port.

Is it possible?

Thanks

3 REPLIES
Hall of Fame Super Red

Re: Is possible to configure NM-4B-S/T BRI for voice?

Hi Solo,

Sorry, this card is a NM - Network Module and will not support Voice :( There are some VIC - Voice interface choices that will work listed in this doc;

http://www.cisco.com/en/US/products/hw/modules/ps5365/products_data_sheet09186a0080191d41.html

Hope this helps!

Rob

New Member

Re: Is possible to configure NM-4B-S/T BRI for voice?

If I want to use 4 BRI for Voice, what is your suggestion?

Thanks

Hall of Fame Super Gold

Re: Is possible to configure NM-4B-S/T BRI for voice?

Either 2 x VIC2-2BRI-NT/TE, or an addon module for EVM, (that is useable only on 2821 and bigger router).

115
Views
0
Helpful
3
Replies
CreatePlease to create content