Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Is there a way to Read NANP

All,

In CUCM 4, you can read and customize NANP to suit your organization. Is there a way to see what is inside NANP? We have experienced some problems with route patterns and believed they might be related to NANP. I tried to use CLI commands searching NANP, just could not find the file.

Thanks,

Wenqian

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Is there a way to Read NANP

2 REPLIES
Cisco Employee

Re: Is there a way to Read NANP

You can do a dialing forest dump to see what patterns are included in the NANP.  First go to your service parameters and set to True (under advanced) "Dialing Forest Dump Enabled".  Then from an IP phone dial, **##*2, you'll hear reorder or annunciator, hang up, then dial **#*4, you'll again get reorder or annunicator, hang up.  Then collect the CallManager traces from the server the phone that dialed those patterns are dialed to. You'll get output in the trace file of what patterns are dialable including what is in the NANP.

Here's the same thing: http://www.ciscotaccc.com/kaidara-advisor/voice/showcase?case=K26897263

Cisco Employee

Is there a way to Read NANP

880
Views
0
Helpful
2
Replies