Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ISDN BRI in Malta Urgent help on config settings

Hi, I have posted a comment on this previously but am still having issue.

I have a SRST gateway which I remotely maintain from the UK in Malta, however the ISDN lines spend more time in a down state than up. When I remote to the gateway a show ISDN status shows the BRI layer 1 in a Deviated state.

The Telco have stated that the lines are working when they plug their tester in.

The MGCP config is as follows:-

BRI Net3

PCM A-LAW

Inhibit Restart at BRI initialization check on

Point to point set up is on

TEI Negotiation is on Power-up

TEI preservation - reserve

TEI mode is dynamic

TEI value is 0

Line power is off

Layer 1 protocol side is user.

I am unable to attain any info from the Telco for the correct settings. I would appreciate it if anyone can confirm/advise on what the correct ISDN settings should be.

Regards

Richard

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: ISDN BRI in Malta Urgent help on config settings

What is the issue exactly ? Can the line place and receive calls ?

As mentionen previously it is normal that the line goes down when not use.

Then post any complete show command output, because "Deviated" is nto an ISDN status.

Finally, note that MGCP often have too many bugs, and a H.323 or SIP configuration would be more robust.

3 REPLIES
Hall of Fame Super Gold

Re: ISDN BRI in Malta Urgent help on config settings

What is the issue exactly ? Can the line place and receive calls ?

As mentionen previously it is normal that the line goes down when not use.

Then post any complete show command output, because "Deviated" is nto an ISDN status.

Finally, note that MGCP often have too many bugs, and a H.323 or SIP configuration would be more robust.

New Member

Re: ISDN BRI in Malta Urgent help on config settings

Hi p.bevilacqua

Have managed to get a response from the Telco, my issue was with the TEI being dynamic, I have set it to static and a value of 0 and it now works.

Took 6 months for them to get back to me.

The customer wants MGCP gateways "Group stnadard" but am poised to configure it to h323 if they have issues.

Again many thanks for your help.

Hall of Fame Super Gold

Re: ISDN BRI in Malta Urgent help on config settings

Hi, had you mentioned that for example you have DID, or multiple lines under same number, I could have suggested that TEI had to be static.

176
Views
0
Helpful
3
Replies