I am having a lot of problems setting up a VWIC BRI in a Cisco 1861 that is connected BRI in Malta. As I am working on this remotely I am having a lot of difficulty getting information to configure this.
The ISDN's will be under MGCP control; however when I carry out a âshow ISDN statusâ the layer 1 is showing as DEACTIVATED. If possible please could someone give me some guidance on the general setup.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.