Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ISDN BRI Not working with h323 gateway

We are using NM-4B-S/T= as a ISDN BRI card to terminate ISDN BRI lines from service provided to make incoming and outgoing calls on H323 gateway. I am facing a problem of with error as below.

025786: *Apr 23 08:12:12.716: ISDN BR2/2 **ERROR**: accept_incoming_csm_call: modem problem Bearer capability not available(0x3A): b channel 0, call id 0x8B.

I have also added isdn incoming-voice modem command as per the isdn disconnect cause codes. But still the problem persist. We have tested BRI line with BRI Analyzer and calls are landing on it successfully.

Is this NM-4B-S/T= supported to make and receive voice calls.

I have successfully tested calls made from analog lines on the same gateway, Problem is only with the BRI lines.

Kindly suggest,

Regards,

Nitesh

4 REPLIES
Gold

Re: ISDN BRI Not working with h323 gateway

Hi,

Try to add this command to your voice ports:

bearer-cap Speech

Hope this helps,

Juan Luis

New Member

Re: ISDN BRI Not working with h323 gateway

Hi Juan,

I am using c3845-spservicesk9-mz.123-11.T11.bin" IOS on my Gatway router. And the command bearer-cap speech is not supported.

Kind Regards,

Nitesh

Hall of Fame Super Gold

Re: ISDN BRI Not working with h323 gateway

Hi,

No the NM-4B-S/T does NOT support voice calls, data only. Only VIC-2BRI (first letter V as in Voice) will support voice.

Hope this helps, if so please rate post!

New Member

Re: ISDN BRI Not working with h323 gateway

Hi,

This was card issue and it got resolved by replaceing the card with VIC-2BRI.

Thanks for all your help.

Regards,

Nitesh

229
Views
5
Helpful
4
Replies