hi guys, i have configured the 2811 with a pri-group,dial-peer,destination........(10 digits..2811 is connected to a voice server/isdn-pri which originates the call and passes it on to the 2811, my target ip is 192.168.x.x,which is a multitech(voip gateway)already in my network connected to a juniper..
Problem:I get an error msg:Cause i = 0x82A6 - Network out of order...
I can ping the 2811 from the multitech, but cannot ping the multitech from the 2811....any ideas, do i have to define any type of route in the cisco2811.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.