hi. ive posted a bit earlier as well, same problem. but now ive advanced a bit.
through all the doc's that ive seen,
all of them have the voice-port interface. i cant get to that command. my ios is 2800NM-IPVOICEK9-M), Version 12.4(15)T1, perhaps im doing something in the wrong order?
what steps do i need to follow next,
in order to be able route my incoming calls to the appropriate phone?
ahh...i didnt mention in my original post how my network is layed out..
i have my cisco router 2811...and anything that comes into it is forwared by nat out the fa0/0 interface where there is a asa5505.
my vlans reside from there on out. my router doesnt have any vlan configurations. the asa5505 take what ever comes into its outside port and forwards it to the appropriate vlan. after the asa 5505 i have a cisco catalyst express500...
so basically, what are the steps (in general or not) that i need to follow to get the voice routed inside.
ive added my bri interfaces so you can have a proper look:
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...