He have CUCM 8.6 and 2911er Series Voice Gateways. We now want to integrate/use up to 20 ISDN modems. Is there some kind of hardware outsite like VGV224 analog trunk panel or 187 ATAs? We will have a E1 interface on voice gateway site where all the ISDN modem traffic will go through. But there is no place in this router to install as much BRI Interface modules to get 20 ISDN modems up and running.
Either Cisco routers with many modules, or third party for which I have no idea, and for which Cisco does not guarantee interoperability. However it is is possible (I'm not sure) that cisco interface support ST multipoint, in that case you could connect multiple TE devices to a same port.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...