I'm probably over thinking, so I'd like to throw this out there to see what everyone's responses are. When a vendor asks you to find out what a ISDN circuit protocol and what CPE type is for a certain circuit, they are asking for what the encapsulation is configured that controller card/port and if it's a Cisco router and what model it is right? Or am I way off?
IntroductionCUCM Routing RulesDial String implementation PolicyCUCM Routing LogicSIP URI Call Routing Analysis+++ Case Study: 1 ++++++ Case Study: 2 +++Conclusion
Over the last few months, I have had the privilege of working on SI...
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...