isdn switch-type ?

[flash2200]

Quick question: If a PRI has been ordered and provisioned to use ISDN protocol "NI-1" what does this correspond to when configuring the "isdn switch-type ????" command on the PRI?

Do I use "isdn switch-type primary-ni"?

TIA for any assistance

[dezoconnor]

Hi, according to this document there is no NI-1 standard for PRI only for BRI!

http://www.cisco.com/en/US/tech/tk801/tk379/technologies_tech_note09186a0080093d6d.shtml

Might be worth checking with your telco what has been provisioned again.

If it is a PRI it may just be a typo with the 1 and you would configure isdn switch-type primary-ni

If its a BRI you would configure isdn switch-type basic-ni.

HTH

[flash2200]

Thought it was odd. Thanks very much!