Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ISDN switch type

Our 3845 ISR (12.4(15)T1)only has ISDN switch-type of "primary-ni", and our Unified Manager 6.0 only has NI2 option for ISDN switch-type. Our telco told us their switch is NI2, but our CM Express has been working for months with the gateway set as NI.

Will the ISDN switch type difference (ni/ni2) cause the gateway "endpoint" to not register properly?

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: ISDN switch type

No, it will not.

Beside the fact that NI and NI2 are interoperable, if you use MGCP, which switch type you have configured on the GW, is immaterial, except for SRST.

Hope this helps, please rate post if it does!

2 REPLIES
Hall of Fame Super Silver

Re: ISDN switch type

There will be no problems with using Primary-NI, go ahead and select it.

HTH,

Chris

Hall of Fame Super Gold

Re: ISDN switch type

No, it will not.

Beside the fact that NI and NI2 are interoperable, if you use MGCP, which switch type you have configured on the GW, is immaterial, except for SRST.

Hope this helps, please rate post if it does!

402
Views
0
Helpful
2
Replies