03-30-2008 03:52 PM - edited 03-15-2019 09:44 AM
Hello
I already interliguei cisco voice gateway with Philips and Avaya PABX by ISDN QSIG. In both, the name called was not transmitted. I saw some papers and discussions here in netpro with professionals with the same diagnosis. But if I connect two PABX Siemens by ISDN QSIG this information now. If I connect two PABX Philips also. Siemens has a protocol called T-QSIG which is the QSIG changed. Philips I know but should use something like that. My question is: If I interconnect 2 cisco voice gateway by ISDN QSIG (even knowing that other interconnections would be best, but as a curiosity), the name would be called shared?
Thanks
03-30-2008 04:17 PM
If you these are GWs for CM with MGCP, name support depends by the qsig settings in gw configuration page.
Else configure "voice service voip - qsig decode" and name will be supported.
Hope this helps, please rate post if it does!
03-30-2008 04:25 PM
Hi
"voice service voip - qsig decode", only between Cisco GW or between GW and PABX another vendor too?
Thanks
03-30-2008 11:49 PM
Works with anyone.
Boa interligacao!
03-31-2008 05:13 AM
I'll go configure this week!
Obrigado!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide