Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ISDN

Hello

I already interliguei cisco voice gateway with Philips and Avaya PABX by ISDN QSIG. In both, the name called was not transmitted. I saw some papers and discussions here in netpro with professionals with the same diagnosis. But if I connect two PABX Siemens by ISDN QSIG this information now. If I connect two PABX Philips also. Siemens has a protocol called T-QSIG which is the QSIG changed. Philips I know but should use something like that. My question is: If I interconnect 2 cisco voice gateway by ISDN QSIG (even knowing that other interconnections would be best, but as a curiosity), the name would be called shared?

Thanks

4 REPLIES
Hall of Fame Super Gold

Re: ISDN

If you these are GWs for CM with MGCP, name support depends by the qsig settings in gw configuration page.

Else configure "voice service voip - qsig decode" and name will be supported.

Hope this helps, please rate post if it does!

New Member

Re: ISDN

Hi

"voice service voip - qsig decode", only between Cisco GW or between GW and PABX another vendor too?

Thanks

Hall of Fame Super Gold

Re: ISDN

Works with anyone.

Boa interligacao!

New Member

Re: ISDN

I'll go configure this week!

Obrigado!

129
Views
7
Helpful
4
Replies
CreatePlease to create content