We can´t forward calls from any device in CUCM 7.1. We press the CFwALL button and while we are dialing the number we receive a fast busy tone. It happens only with pstn numbers. I have tried many CSS and I have restarted services as Callmanager or Cisco Tomcat. Do you have any idea?
This issue started yesterday because all was working fine.
Please make sure you are using the correct dialing string, (if you need to press 9 to get the PSTN then set the number as 9 XXX XXX XXXX or whatever your PSTN dialing string is), also make sure that the phones have the correct CSS for CFALL on the DN settings page.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...