i have successfully mated the plantronics CS55 headset with the cisco IP phone 7962. now my only issue is, when i use the headset, the audio sound is still being sent to the hand held receiver. did i configure it incorrectly? i don't think so as i am using both ports on the back of the phone (one for the headset and the other for the hand-held receiver). i am thinking there must be a way to have the audio signal not sent to the handset when i use the headset.
currently i am just unplugging the cord into the handset when i use the headset, but that is quite annoying.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.