Issue with inbound calls identification (CLI) on Bri Interfaces
Before explain my problem, let me say thanks for your help.
I have a customer with a 2821 router ( 3 BRI interfaces) connecting to cisco callmanager , the problem is that when the customer receive an inbound call they see on the display " anonymous , i attach you the config and the debug isdn q931,
Can you provide me a command guide or something else?
Re: Issue with inbound calls identification (CLI) on Bri Interfa
You cannot do anything about it, because the call comes as anonymous from telco:
Dec 22 10:53:02.326: ISDN BR0/1/0 Q931: RX <- SETUP pd = 8 callref = 0x53 Bearer Capability i = 0x8090A3 Standard = CCITT Transfer Capability = Speech Transfer Mode = Circuit Transfer Rate = 64 kbit/s Channel ID i = 0x89 Display i = 'Anonymous' Calling Party Number i = 0x21A0, N/A Plan:ISDN, Type:National Called Party Number i = 0xA1, '696044805' Plan:ISDN, Type:National Sending Complete
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...