Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Silver

Issue with Incoming calls

Hi All,

Could you please look at the following debug output and the config and let me know why we are receiving two Calling party numbers for a single call but no called number?

Thanks,

The call comes in with two calling numbers (66244833104 and 6626564) but no called number:

------------------------------------------------------------------------------------------

043963: Feb 14 08:33:01.758:

043964: Feb 14 08:33:06.754: ISDN Se0/0/0:15 Q931: RX <- SETUP pd = 8  callref = 0x019A

        Bearer Capability i = 0x9090A3

                Standard = CCITT

                Transfer Capability = 3.1kHz Audio

                Transfer Mode = Circuit

                Transfer Rate = 64 kbit/s

        Channel ID i = 0xA9839F

                Exclusive, Channel 31

        Progress Ind i = 0x8083 - Origination address is non-ISDN 

        Date/Time i = 0x0C020E0821

                Date (dd-mm-yr)   = 12-02-14

                Time (hr:mnt:sec) = 08:33:108

       Calling Party Number i = 0x2180, '66244833104'

                Plan:ISDN, Type:National

        Calling Party Number i = 0x2183, '6626564'

                Plan:ISDN, Type:National

Here's the config:

!

!

trunk group PRI

hunt-scheme round-robin

translation-profile incoming did

!

!

trunk group BRI

hunt-scheme round-robin

translation-profile incoming did

!

!

!

!

voice translation-rule 1

rule 1 /^.*\(..\)/ /613\1/

rule 2 /^$/ /61355/

!

!

dial-peer voice 999999 pots

trunkgroup BRI

trunkgroup PRI

incoming called-number .

direct-inward-dial

2 REPLIES
Hall of Fame Super Gold

Issue with Incoming calls

You should really ask telco that.

Silver

Re: Issue with Incoming calls

Just to let you guys know that we managed to resolve the issue with adding the following commands. It was a timer issue.

interface Serial0/0/0:15

no ip address

encapsulation hdlc

isdn switch-type primary-net5

isdn overlap-receiving T302 6000 / added overlap-receiving

dial-peer voice 1 voip

destination-pattern 613..T / add T

modem passthrough nse codec g711alaw

voice-class codec 1

voice-class h323 1

session target ipv4: X.X.X.X

dtmf-relay h245-signal h245-alphanumeric

fax-relay ecm disable

fax rate 14400

fax protocol t38 nse ls-redundancy 0 hs-redundancy 0 fallback pass-through g711alaw

no vad

235
Views
0
Helpful
2
Replies
CreatePlease to create content