Issue with video (vta calls) between CME and CUCM connected by H.323
I have integrated the CME with our Call manager using H.323. I have verified that the audio calls between phones registered to CME and those registered to CUCM are working fine. I have configured the required commands for the video (VTA) to work. Also, the video window is popping up once the call is established, but no video is being displayed. Could you please help me in fixing this issue? I can confirm that the cameras/VTA everything is working fine for all these phones.
Here is the configuration I have done on CME for video:
voice service voip
call start slow
maximum bit-rate 256
service phone videoCapability 1
When I do a “show call active video” on the CME, I get:
Is this problem with the codec mismatch? If so what should I do to fix it?
Issue with video (vta calls) between CME and CUCM connected by H
I am facing a similar issue between a CME and CUCM using a H323 link. - If the issue is resolved can you pls share the solution.
The 7940 SCCP sets on the CME can make and recieve calls to / from CUCM.
The 9951 (SIP) set on the CME site can make calls only when the "Video" is disabled on the set. When the Video is enabled on the set, the call does not establish and gets disconnected immediately after dialing the remote number.
Note that a CME to CME video call is possible - I am running 8.6
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.