im having iisues config a cisco ata 187 for sip, i can access the web interface via its ip address which displays information about the device but none of it can be modified. I can not access it when i add /dev to the address. I get page can not be displayed.
The ATA-187 shares very little in common with the -186 [thankfully]. The -187 is configured entirely through CUCM. It pulls the configuration file down as other Cisco IP phones do. If you want an independent analog gateway that you can configure you will need to use a VG202 or VG204; they are IOS-based.
Note that the -187 is only supported with UCM 7.1(5) and 8.0(x) per the release notes and requires a feature package installation to see the device type.
how to change tftp server of Cisco ATA 187 as by default its getting a tftp server which is 10.10.X.X but i want to change the tftp server in order to register the Cisco ATA 187 with Cisco CallManager 7.1.
I coudn't configure the network setting from web page. Thanks
IntroductionCUCM Routing RulesDial String implementation PolicyCUCM Routing LogicSIP URI Call Routing Analysis+++ Case Study: 1 ++++++ Case Study: 2 +++Conclusion
Over the last few months, I have had the privilege of working on SI...
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...