its-CISCO.184.108.40.206.tcl script on Cisco 2800 problem
I have a problem with its-CISCO.220.127.116.11.tcl script. I downloaded this file from Cisco and run on my Cisco 2800 voice gateway. The problems are:
- I can not hear prompt. I take a inbound call from PSTN, it connect but no prompt.
- I press 0 for operator but it takes about 10 seconds to connect to operator number. It's too long, right? How can I fix it?
Here are some outputs of configuration, flash: content and debug voice application script:
! voice class custom-cptone vn dualtone disconnect frequency 425 425 cadence 500 500 continuous ! voice-card 0 ! application service inbound_ivr flash:its-CISCO.18.104.22.168.tcl param aa-pilot 499 paramspace english index 0 paramspace english language en paramspace english location flash: param operator 4100 paramspace english prefix en
IntroductionCUCM Routing RulesDial String implementation PolicyCUCM Routing LogicSIP URI Call Routing Analysis+++ Case Study: 1 ++++++ Case Study: 2 +++Conclusion
Over the last few months, I have had the privilege of working on SI...
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...