Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Its possible a 7941 with 7914 addon on CCME?

Hello,

I would like to know if it is possible to attach the 7914 addon on the 7941 phone, like the 7940.

With the 7940 works adding "type 7960 addon 1 7914" on the ephone config, but I'm trying to do the same with the 7941 and it doesn't work.

I tried uploading/downgrading the firmware version of the 7941 and the 7914 without success.

This is the tftp event debug message:

---------------------------------------

"5w5d: TFTP: Looking for S00104000100.SBN

5w5d: TFTP: Opened flash:S00104000100.sbn, fd 0, size 49169 for process 154

5w5d: TFTP: Finished flash:S00104000100.sbn, time 00:00:00 for process 154

------------------------------

Configuration commands:

-----------------------------------------

tftp-server flash:S00104000100.sbn

telephony-service

load 7914 S00104000100

ephone 22

mac-address 001D.xxxx.xxxx

type 7961 addon 1 7914

button 1:12

---------------------------------

The 7941 boot the first time with a "OK" square, then reset 3 or 4 times whit the "wrong" square on the left-bottom corner, and finally the 7941 remains registered and the 7914 with the red buttons on.

The ios version is 12.4.11T4.

Thank You

2 REPLIES

Re: Its possible a 7941 with 7914 addon on CCME?

According to Cisco the 7914 is only supported on the models listed in the following data sheet:-

http://www.cisco.com/en/US/products/hw/phones/ps379/products_data_sheet09186a008008883d.html

Regards

Allan.

New Member

Re: Its possible a 7941 with 7914 addon on CCME?

Hi Allan,

I know it, 7914 don't support 7940 but it works, may be it works with the 7941...

Regards

Gerard

773
Views
0
Helpful
2
Replies