12-11-2007 01:00 AM - edited 03-15-2019 07:42 AM
Hello,
I would like to know if it is possible to attach the 7914 addon on the 7941 phone, like the 7940.
With the 7940 works adding "type 7960 addon 1 7914" on the ephone config, but I'm trying to do the same with the 7941 and it doesn't work.
I tried uploading/downgrading the firmware version of the 7941 and the 7914 without success.
This is the tftp event debug message:
---------------------------------------
"5w5d: TFTP: Looking for S00104000100.SBN
5w5d: TFTP: Opened flash:S00104000100.sbn, fd 0, size 49169 for process 154
5w5d: TFTP: Finished flash:S00104000100.sbn, time 00:00:00 for process 154
------------------------------
Configuration commands:
-----------------------------------------
tftp-server flash:S00104000100.sbn
telephony-service
load 7914 S00104000100
ephone 22
mac-address 001D.xxxx.xxxx
type 7961 addon 1 7914
button 1:12
---------------------------------
The 7941 boot the first time with a "OK" square, then reset 3 or 4 times whit the "wrong" square on the left-bottom corner, and finally the 7941 remains registered and the 7914 with the red buttons on.
The ios version is 12.4.11T4.
Thank You
12-11-2007 01:13 AM
According to Cisco the 7914 is only supported on the models listed in the following data sheet:-
http://www.cisco.com/en/US/products/hw/phones/ps379/products_data_sheet09186a008008883d.html
Regards
Allan.
12-11-2007 01:18 AM
Hi Allan,
I know it, 7914 don't support 7940 but it works, may be it works with the 7941...
Regards
Gerard
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: