Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

Jabber 10.5 and 9951 model IP Phone

Hi,

 

When I try to switch call controls to my terminal phone 9951 it is rejected. However models 8945 and 6945 are right. 

Version CUCM is 8.6 and IP phone are using firmware sip9951.9-4-1-9

 

                                                                         Thanks, Jorge.

 

Everyone's tags (1)
1 ACCEPTED SOLUTION

Accepted Solutions

Do you have the "Standard CTI

Do you have the "Standard CTI Allow Control of Phones supporting Connected Xfer and conf" access group assigned to the Jabber user?

Please rate useful posts.
2 REPLIES

Do you have the "Standard CTI

Do you have the "Standard CTI Allow Control of Phones supporting Connected Xfer and conf" access group assigned to the Jabber user?

Please rate useful posts.
New Member

It´s works, thanks a lot.It´s

It´s works, thanks a lot.

It´s the first time I attach a 9951 and Jabber.

 

Regards, Jorge. 

6
Views
14
Helpful
2
Replies
CreatePlease to create content