Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Jabber for Windows and G.722

                   Hello, we have 99xx Phones which uses G.722 as Codec within CUCM 8.5.

                   When i use Jabber for Windows Client 0.0.1 as softphone the codec is switched back to G711 (Call from Softphone to 99xx Phone)

                   I read that Jabber should support G.722.

                   Is there someone which  have the Jabber Softphone working with G.722?

br Mike

Everyone's tags (3)
4 REPLIES
Cisco Employee

Jabber for Windows and G.722


Note


g.722.1 is  supported on Cisco Unified Communications Manager 8.6.1 or  later.

http://www.cisco.com/en/US/partner/docs/voice_ip_comm/jabber/Windows/9_0_1/b_jabber_win_icg_chapter_01000.html

HTH

java

if this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
Bronze

Jabber for Windows and G.722

I'm seeing the same behavior on CUCM 9.1.1a.  IP phones calling a G.722-capable route pattern connect to it in G.722 (using 7945's  and 7937's), Jabber 9.2.4 connects at G.711u.  Since the call is working with G.711u, that tells me that it's not an issue with Region configuration (which was legacy from an upgrade from 8.6.2).

Any other thoughts there?

New Member

BUMPSame issue, CUCM 8.6

BUMP

Same issue, CUCM 8.6.2SU4a

All intranet calls are g722, but to jabber it's g711u

New Member

I should have read the

I should have read the release notes.

 

Jabber supports g.722.1, not g722. So if you're looking for g722 support - it's not there. g722.1 is half bw of g722, and from the opinion of my peers - it sounds better than g711 and uses half the bw.

 

B

1368
Views
0
Helpful
4
Replies
CreatePlease login to create content