Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Kill/end a specific call.

Hello,

Is there a command to kill/end a specific call?

Regards.

5 REPLIES
Community Member

Re: Kill/end a specific call.

Hello,

Is there a command to kill/end a specific call on a Cisco GW AS5300/AS54000 ??

Regards.

Re: Kill/end a specific call.

If you use 'show call active voice brief' you can get the 4 digit HEX ID for a call based on calling/called number and remote IP address and channel.

Then you can use the command:

clear call voice causecode id , you can also try using the called/calling options instead of ID.

hth,

nick

Community Member

Re: Kill/end a specific call.

Hello,

I can't run that command. I just have:

GW#clear call ?

fallback VoIP Fallback

threshold Clear stats about resource measurement

treatment Clear commands for call admission

Is there another way to perform this?

Best regards.

Re: Kill/end a specific call.

It sounds like you need to upgrade IOS to use this command.

There isn't another way, unless you shut down voiceports/controllers.

-nick

Community Member

Re: Kill/end a specific call.

Hello,

I'm running Version 12.3(26) over a AS5300, isn't it the latest?

Regards.

142
Views
0
Helpful
5
Replies
CreatePlease to create content