Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

KIRK 600v3 one way audio

Hi

I have an issue with one way audio in KIRK handsets connected to CUCM ( 6.1.3  , 7.1.3 ).

One way audio -  the consequence of handset registration, I suppose my Handest should be seen in CUCM with KIRK 600v3 ip address, but it it seen wiht CUCM address or 0.0.0.0 ?

Any ideas ?

Greetings

Marcin

1 REPLY
New Member

Re: KIRK 600v3 one way audio

I had the same Issue, you may configured ETH1 instead of ETH0 on Polycom KIRK 600v3 Webinterface. In My case i turned off DHCP and deleted all IP adress entries on ETH0. I mentioned it, after i rebooted the UC540; the Polycom KIRK 600v3 tried to register ephones under IP:192.168.0.1, which was configured on ETH0.

Maybe it use ETH0 before it switches to ETH1.

396
Views
0
Helpful
1
Replies