I'm migrating a site that has over 150 speed dials configured. Does anyone have any suggestions? I don't believe I'm going to be able to due this using speed dials since the limit appears to be 99. I was thinking that translation patterns maybe my only choice. I'm currently running CCM 4.2. Tx
Are these system speed dials that everyone is using? If so then TPs are you best bet, unfortunately there is no Bulk way of importing TPs until CM 6.0. Your best way if you dont want to do manual TPs, is to create dummy cti ports or cti route points with the forwardAll destination configured.
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...
You have reached the Cisco Logistics Support Center.. To Check Status of your RMA, visit Product Returns & Replacements (RMA).
Need help? Contact us by Phone or Email.
Phone: 1800 553 2447 Option 4