06-18-2008 07:21 PM - edited 03-15-2019 11:22 AM
Is it possible to configure LCR between two CME sites? I have two different CME's that are in two different states and would like to take advantage of the PSTN connections at both sites. I'm currently using h323 dial-peers for 4-digit dialing and toll bypass, but am not quite sure how to get site A to dial out site B's ISDN line for PSTN calls.
I'm using CallManager Express at both sites.
Any hints?
Thanks.
06-18-2008 10:53 PM
Mike,
This can be done. Make the configuration transparent to the IP phone users, so they will just dial the numbers as long distance numbers. Configure redundancy via dial-peers. Two dial-peers will do the trick. The first dial-peer will send the call to the remote gateway for it to be routed out as a local call. If the number dialed is dialed as 91+10 digits, strip the 91 (and the area code if necessary) before sending the call to the remote gateway which should already be configured to route the call out as a local call. The second dial-peer is a failover dial-peer, to be used incase the WAN is down or the remote gateway is not available to route out the call. In this case, the call is sent out the local gateway as a normal long distance call.
The configuration could look somewhat like this:
!
voice translation-rule 4
rule 1 /^91212/ /212/
!
voice translation-profile LCR
translate called 4
!
dial-peer voice 1 voip
description ** LCR Via CME_Site_B **
destination-pattern 91212[2-9]......
translation-profile outgoing LCR
preference 1
!
dial-peer voice 2 pots
description ** LD to CME_Site_B Via Local PSTN**
destination-pattern 91212[2-9]......
preference 2
forward-digits 11
port x/x
!
Hope this helps.
Michael.
06-19-2008 12:55 PM
Michael,
Thanks for the quick reply and the suggestions.
It turns out that I was over complicating things by adding an incoming dial-peer at my far-end system. As soon as I removed that the incoming VoIP calls started routing out the PSTN.
I'll use your preference suggestions for failover dial-peers.
Thanks much,
Mike
06-19-2008 01:48 PM
You are welcome Mike. Good to hear that all is well in your VoIP world :-)
Regards,
Michael.
01-26-2015 04:05 AM
Hi,
Can you please refer to a configuration guide? I would need that quite urgently and I cannot find a general guide so far.
Thank you,
Cecilia
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: