I have a setup that I need to verify before I get in any trouble.
I have a 2811 router that is acting as a voice gateway on a network that has CCM 6.x. The router has a VWIC-1MFT-E1 card that terminates a digital E1/PRI trunk carrying 30 phone lines with a hunt group number.
The new requirement is a legacy machine in my environment that requires remote access over legacy analog telephone line. What I'm thinking of is adding a VIC-2FXS and connecting this modem directly to this FXS VIC. However I'm not quite sure if:
FXS VICs support modem relay/pass-through?
If it does, then what is the most suitable way to forward a call arriving on the digital trunk calling a hunt group number to a physical FXS port? Can I assign a DID number which can be auto-forwarded to the FXS port? Use the help of an operator to manually transfer the call?
I checked the usage of an ATA186 but apparently they don't support modem relay/pass-through !
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...