Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Let the gateway insert a pause and then append the dialed number with a specific digit code.

Does anyone know how to send an authorization code to a carrier AFTER  the digits are sent over to the Gateway 

We are looking  to have the gateway  insert a pause and then append the dialed number with a specific 3 digit  code.

I was thinking of doing the following setup:

Creat a RP for FAX and prefix 111 (A FAC Code) and DD preDot

In the gateway i create my dialpeer

dialpeer voice 1 pots

destination-pattern 111,T

port 1/1/1:23

with the , i can insert a pause ....

Can anyone tell me if this would word and any other ideas!

Thanks

2 REPLIES
New Member

Re: Let the gateway insert a pause and then append the dialed nu

Any specific reason that you would like to insert a pause?

If not, i think a translation rule will work. apply it to the voice port- outgoing direction, called number

Prefix 111 on dial peer

voice translation-rule 1

rule 1 /^\(111\)\([1-9].........\)$/   /\2\1/

New Member

Re: Let the gateway insert a pause and then append the dialed nu

Thanks Arun, but basically i need to send the first 10digits to the voice port then wait for 3 seconds and then enter the Fac code , the fac code are provided by the service provider and i can t just prefix digit.... i have to wait so i get dial tone and the number got through the port then send the Fac code .

Any thoughts on that?

Btw thanks for your response

Sent from Cisco Technical Support iPhone App

176
Views
0
Helpful
2
Replies
CreatePlease login to create content