Apparently I like acronyms :-). Here are my specs and my issue:
My problem is I have a call coming into the PRI, say, 555-555-5555. I only want this number to be called three times before getting a busy signal. I have found no way to do this. I have the incoming number translated to a hunt group of ten phones, however, I only want three calls maximum to enter the hunt group. I don't want people to have to login to a hunt group or do any manual procedures.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.