Our customer has a very poor legacy dialplan design with internal DN's which do not map neatly to the telco DDI (oh for a perfect world). They have a requirement to present an outbound DDI uniquely for each extension (about 60) on CME.
Despite being creative with the dialplan masks we can only accomodate about 40 of the 60 extensions using an outbound translation pattern on the PRI.The limit of 15 riules in a translation pattern is a problem for us.
I could configure a translation pattern on an ephone-dn but this would also affect internal calls so won't work for us.
So, I have been considering our options. The only thing I can think of is to create a number of outbound PSTN dial-peers but configure these with an incoming-number so only calls from certain DN's will use that outbound dial-peer. Then i can have a translation pattern on each outbound dial-peer where the 15 rules won't be a limiting factor.
This will potentially involve a lot of reconfig work so before I do it I wondered if anyone has any thoughts or indeed has resolved this issue in any way ?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...