I have a need to send 13 calls over a 2MB pipe at g711. The issue is that I never want the system to allow a 14th call. The issue I have Is that I have 2 Dial-Peers one from and one to my SIP provider. Does anyone know If there is a way to dynamicall set the maximum to be 13 so I could have 6 in 7 out one minute then 12 out 1 in the next?
Thanks for the reaply,im using the Max-Con = x in each dial pair this limits the number of calls but because its a fixed number It causes me an issue.I dont have access to both ends of the call I can`t control that.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...