If I dial a hunt group internally the line group algorithm (Top Down)works fine, however if I dial the DID linked to the hunt group from my cell phone the line group algorithm doesn't work it hits the first person in the group then stops and goes to vm. Ideas? MGCP GW CM 4.2.3sr3. The partition linked to the hunt pilot is assigned to the CSS assigned to the pstn gateway.
Does the first person in the hunt group have forward to voicemail configured? Not sure on CCM4.2 but I know on earlier versions having call forward set on a phone would affect incoming calls to a hunt group that phone belonged to.
If this is the case change the phones forward to voicemail timer to greater than the hunt groups no answer timer.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...