Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Line Group

I have cucm 7.0

Have configured a hunt group with 3 extensions.

Have set the pilot for DDI.

When I call in from PSTN. It only calls two extns. never the third. Does this all the time.

If you call the pilot internally, it works fine.

I can only assume there is something on the gateway causing this.

any ideas

2 REPLIES

Re: Line Group

Hi,

You can try to use a translation pattern to your E.164 number] then put the hunt pilot [another internal extension]

in the called party transformation mask [another internal extension]

thanks

New Member

Re: Line Group

thanks for your reply.

I am not sure what this is going to achieve?

131
Views
0
Helpful
2
Replies