The Power LED flashes Once and then Twice really fast
After using my PAP2v1/Unlocked for a years now I cant see it at all on my network. The Power LED flashes Once and then Twice really fast. If I plug in the network cable the Ethernet led stays off. I have done the factory reset via the IVR and hardware but it doesn't seem to help it. The only thing I can seem to get into is IVR menu after four ****.
Any recomendations? Any sugestion will be useful Thanks,
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...