Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Linksys PAP2T Power led says "SOS" !?

Hi there !

My Linksys PAP2T  is suddenly OOO and power LED says "SOS" !

I can't enter the setup with the IP address.

Whar appens ?

What can I do ?

Thank's for your help !

Snoopy

3 REPLIES

Linksys PAP2T Power led says "SOS" !?

Hi Snoopy,

Check out the following document:  https://supportforums.cisco.com/docs/DOC-9901

Also, you would receive more help in the Small Business forum.

HTH,

Chris

New Member

Re: Linksys PAP2T Power led says "SOS" !?

Hi Chris !

Thanks for the document but ... what can I do now ???

Snoopy

2012/2/5 clileikis

**

Home <> Re: Linksys

PAP2T Power led says "SOS" !? created by clileikis<>in

IP Telephony - View the full discussion<>

New Member

Linksys PAP2T Power led says "SOS" !?

After years of stability, my PAP2T-NA abruptly started flashing the SOS code.  The recovery tool referenced at

https://supportforums.cisco.com/thread/2021677 was unable to find my device, so I assumed it was dead and ordered another one.  When it arrived, I disconnected the old one, connected the new one, and it promptly flashed the SOS code, too!  The recovery tool was unable to find that device, either, and at some point I decided to connect both at the same time.  To my amazement, the recovery tool found the one I connected to the new power adapter.  I swapped adapters and the other one was found, too!  A multimeter measured 5.1VDC for both power adapters, so I can't explain this behavior, but in my case the only problem was the power adapter!

4329
Views
0
Helpful
3
Replies
CreatePlease to create content